Posts Tagged: Puch E50

3d Printed Puch E50 Water Cooled Head

I drew up a Water Cooled Puch E50 head in 123d Design. I printed it out with a 3d printer with low infill. This will allow it to be flask casted with aluminum. The holes were slightly smaller so that

3d Printed Puch E50 Water Cooled Head

I drew up a Water Cooled Puch E50 head in 123d Design. I printed it out with a 3d printer with low infill. This will allow it to be flask casted with aluminum. The holes were slightly smaller so that

Puch E50 Rebuild

Here is a Puch E50 that I rebuilt for a project I am working on. You can find manuals online. There is a great tutorial on how to rebuild them here: http://www.mopedarmy.com/wiki/Rebuild_a_Puch_E50_Engine After looking at that tutorial and downloading a

Puch E50 Rebuild

Here is a Puch E50 that I rebuilt for a project I am working on. You can find manuals online. There is a great tutorial on how to rebuild them here: http://www.mopedarmy.com/wiki/Rebuild_a_Puch_E50_Engine After looking at that tutorial and downloading a

KTM Foxi GT

This is my roommates KTM Foxi GT. We did a little bit of work to get it to be a reliable daily rider: The fuel lines were all replaced. The carburetor was cleaned out, the electrical system was kind of iffy,

KTM Foxi GT

This is my roommates KTM Foxi GT. We did a little bit of work to get it to be a reliable daily rider: The fuel lines were all replaced. The carburetor was cleaned out, the electrical system was kind of iffy,