/ Work

Motor and Fan Replacement in a Despatch Oven

  I replaced this motor and squirrel cage fan out of this Despatch Oven. The circulation fan over the years had become encrusted in dust causing it to be out of balance. This wrecked the bearings on the fan. I

/ Work

Motor and Fan Replacement in a Despatch Oven

  I replaced this motor and squirrel cage fan out of this Despatch Oven. The circulation fan over the years had become encrusted in dust causing it to be out of balance. This wrecked the bearings on the fan. I

/ Work

Motor Upgrade for an LA Abrasion Machine

This LA Abrasion Machine had an aging motor on it. I picked something modern that would accept the same shaft diameter for the gear. Then I ordered an equivalent replacement knowing that the frame was going to be an inch

/ Work

Motor Upgrade for an LA Abrasion Machine

This LA Abrasion Machine had an aging motor on it. I picked something modern that would accept the same shaft diameter for the gear. Then I ordered an equivalent replacement knowing that the frame was going to be an inch

/ Work

Saw Guard Bracket

For some reason the first thing people seem to do is take the guard off the table saws and throw them away. This table saw was missing its guard so we just bought a generic one. I lined it up and drilled

/ Work

Saw Guard Bracket

For some reason the first thing people seem to do is take the guard off the table saws and throw them away. This table saw was missing its guard so we just bought a generic one. I lined it up and drilled

123D Catch of MB5 Fairing

  I used 123d Catch to capture this fairing. I need to go back through and take pictures with soft even lighting so I don’t have to edit the 3d model as much.  

123D Catch of MB5 Fairing

  I used 123d Catch to capture this fairing. I need to go back through and take pictures with soft even lighting so I don’t have to edit the 3d model as much.  

1978 Rigid Puch Free Spirit

This is a 1978 Rigid Puch Free Spirit that I have been working on for too long. A previous owner had the shocks welded in with what looks like tubes off of a dolly. I cut off the seat post

1978 Rigid Puch Free Spirit

This is a 1978 Rigid Puch Free Spirit that I have been working on for too long. A previous owner had the shocks welded in with what looks like tubes off of a dolly. I cut off the seat post

Raspberry Pi Case

My cousin needed a Case for a Raspberry Pi Case, so I printed him this one: http://www.thingiverse.com/thing:30572 Glow in the dark ABS was used, it works out fairly well.

Raspberry Pi Case

My cousin needed a Case for a Raspberry Pi Case, so I printed him this one: http://www.thingiverse.com/thing:30572 Glow in the dark ABS was used, it works out fairly well.

3d Printed Puch E50 Water Cooled Head

I drew up a Water Cooled Puch E50 head in 123d Design. I printed it out with a 3d printer with low infill. This will allow it to be flask casted with aluminum. The holes were slightly smaller so that

3d Printed Puch E50 Water Cooled Head

I drew up a Water Cooled Puch E50 head in 123d Design. I printed it out with a 3d printer with low infill. This will allow it to be flask casted with aluminum. The holes were slightly smaller so that